Installing the SE Sport Clip Part 1

11 Comments
X
Share

This is part 1 of a 2 part video detailing the installation of a Sport Marine Tech Drill Free Sport Clip and Hydrofoil. The video shows the installation of the SE Sport 300 but is applicable to installation of the SE Sport 200, also. This installation is shown on an outboard motor and is instructional for a stern drive, also.

source

Read Also

Leave a Reply

Your email address will not be published. Required fields are marked *

Responses (11)

  1. Doesn’t seem to fit Yamaha f20. Has both an anode and the trim fin. Rear anode blocks and makes it stuck too far our

  2. Thank you so much.
    For any small tohatsu owners. My strap and the mounting plate would not allow the anode to catch a thread. Solution put strap on anode and catch a few threads. Then take mounting plate and secure strap. There will be enough wiggle room to get to that Phillips head screw and tighten it.

  3. how did you put the lower free clip plate under the anti cavitation plate??? it is a closed piece. It doesn't fit.

  4. I used it with BRP Evenrude 25 it does't fit (

  5. All i can say is THANK YOU SO MUCH…very good video and very helpful. 🙂

  6. ive used these things in the pasted on many of my boats and ive always lost top end speed,any were from 3 to 5mph..cuse of the added  resistence on the water

  7. probably not depending on the weight of your hull and the cargo including you

  8. I have a 4 meter (13 Ft) speedboat with a 9.9 HP Evinrude, but i cat go into plane. will hydrofoils make my boat able to plane?

  9. This is a very informative video but I strongly feel you can skip some of these steps and go straight to taking off the torque plate and then line up the sport clip.

  10. I used to use one of these until I found the more durable aluminum Orca fin from Uncle norms, it not only helps with my planing ability but maximizes my steering control. I can't say enough how much it has helped me when docking my 22ft Boat.

  11. Hi, just to check with anyone, any idea this SE Sport 300 can be installed on an Evinrude E-tec 300?